Finder adds over-ride and status units to DIN modules

finder
Finder has added new modules to its 19 Series of DIN-rail modules.



Finder has added over-ride and status-monitoring modules to its 19 Series of 35 mm DIN-rail modules.

BMS designers, panel builders and installers will find these over-ride modules essential for providing a manual over-ride of a BMS controller or programmable logic controller — either in 0an emergency or during maintenance. Possibilities include control over pumps, fans, solenoid valves and motors.

The status modules provide a clear visual signal identification and permit BMS and panel designers to set the colour of the status LED during installation. This enables quick identification of operational status, particularly in complex systems.

An analogue output module has been added to the range, with a user-defined output of 0 to 10 V for proportional output setting or speed adjustment.

For more information on this story, click here: May 09, 108
Related articles:



modbs tv logo

Government’s heat pumps plan “doomed to failure”

The Government’s plan to increase heat pump installations is “doomed to failure” without a substantial increase in training for installers, according to consumer advice specialists at The Heating Hub 

Extension welcomed, but a long-term policy is still needed

The Government’s 10-point plan for a Green Industrial Revolution, is a positive step in the right direction 

Calendar