Sponsored blog - Walraven: How to move from over-specified to optimised fixing solutions
In mechanical and electrical (M&E) installations, fixings and supports are often considered minor components, but their impact on cost, sustainability, and efficiency is anything but small.
One common issue that drives up material use, cost and embodied carbon on projects is over-specification. Understanding what it is, why it happens, and how to avoid it can lead to smarter, greener, and more cost-effective projects.
What is over-specification?
At its simplest, over-specification means selecting components with significantly more strength or capacity than the application requires. A familiar example is the widespread use of 41×41 strut channel for light pipework or cable runs that could be safely supported by lighter channel systems. While the installation may perform as intended, the additional steel, weight, and cost of using these over-specified components delivers no real benefit.
Why does over-specification happen?
There are several common drivers for over-specification of M&E fixings on jobsites:
- Playing it safe: Contractors and designers may default to heavier-duty systems to avoid risk or liability.
- Lack of detailed load data: Without reliable calculations, it’s easier to over-engineer than optimise.
- Habit: Traditional strut systems are widely available and well understood, so they become the default choice.
- Time pressure: Tight programmes leave little room for design refinement or value engineering.
The result is a ‘one-size-fits-all’ approach that rarely reflects actual performance requirements.
What does it look like in practice?
Consider a typical plantroom installation with small-bore copper pipework. The loads are modest, yet the design specifies standard strut channel, oversized brackets, and M10 threaded rod throughout. In reality, a lighter channel system with appropriately sized components would meet all structural and safety requirements.
The impact of over-specification here is clear:
- More steel than necessary (increasing embodied carbon)
- Higher material costs
- Longer installation times due to heavier, bulkier components
- Additional load on the building structure
Across a large project, these inefficiencies scale quickly.
How to avoid over-specification
The key is matching the fixing solution precisely to the load and application.
This starts with accurate load assessments, taking into account pipe or cable weight, spacing, and any dynamic factors. From there, contractors should select the lightest system that meets performance and compliance requirements, rather than defaulting to maximum capacity.
Crucially, this is where manufacturer expertise adds value.
Walraven, for example, supports contractors and consultants with technical calculations, system selection advice, and ready-to-spec solutions. Its range of lighter channel systems (Walraven RapidRail®) and modular supports is designed specifically to meet common M&E requirements without the excess material of traditional strut.
The benefits of tailoring the solution to the installation
Moving from over-specified to optimised fixing solutions delivers clear advantages:
- Lower costs: Reduced material use and faster installation
- Improved productivity: Lighter systems are easier to handle and assemble
- Reduced embodied carbon: Less steel means lower environmental impact
- Better coordination: Slimmer systems simplify installation in congested spaces
Importantly, these gains come without compromising performance or safety when delivered correctly.
A smarter approach to specification
As the industry sharpens its focus on efficiency and sustainability, over-specification is an increasingly avoidable problem. With the right data, the right products, and the right support, contractors can move beyond “playing safe” and start specifying with confidence.
Because in today’s market, the best solution isn’t the heaviest or the one you’ve always used, it’s the one that’s precisely fit for purpose.
For support designing fit-for-purpose installations, contact Walraven Technical Support.
Visit our website to find out more.
