BMS interface for water heaters

04 April, 2012

A. O. Smith now offers a BMS interface for its BFC, SGE and SGS ranges of high-efficiency gas-fired condensing water heaters. The SGE and SGS ranges can also operate with solar-thermal panels. The output from the BMS interface is in the Modbus protocol, one of the most commonly used protocols. The interface can be added to existing installations.

The interface can monitor nearly 50 parameters, legionella settings, fault indications, solar contribution, temperatures in the appliance, burning hours etc.

Monitoring legionella settings and checking the program is very important. The BMS interface can register, by processing information about the temperature in the tank, that the legionella program ran at a specific date and time.

For more information on this story, click here: April 2012, 170

Related links:

‘Red tape scrapping is welcome – but more policy changes are needed’

The CEO of heat pump manufacturer Aira UK has said the government’s new proposals to scrap planning red tape for the installation of heat pumps in the UK will be a big breakthrough for the industry and consumers – but more policy changes are needed.

New procurement rules for NHS suppliers

New procurement rules mean NHS suppliers will need to demonstrate their green credentials so the NHS can achieve its target of becoming net zero for directly-controlled emissions by 2040, with an ambition to reach an 80% reduction in its carbon emissions between 2028 to 2032.

Calendar

Submit event

Tweets by MBS_magazine

&#65279;BMS interface for water heaters

Related links:

Related articles:

BMS interface for water heaters