KNX combined controllers and sensors from Siemens

03 April, 2014

The QMX3 range of mounted controllers offers a combined sensor and controller in an easily installed wall-mounted device. The devices include high-quality temperature, CO2 and humidity sensors, as well as integrated PID controllers to control these measured variables. Some units have an LCD display.

Versions with a CO2 sensor can display the actual air-quality status either via a colour-change LED or on the LCD, depending on project requirements. Lighting and blinds can be controlled from the same unit, so no additional devices are required for total room automation control.

The wall-mounted option means installation is not dependent on any given wall box. The units use the KNX open communication protocol.

For more information on this story, click here: April 2014, 202

Related links:

More refrigerant bans possible, says government

The government could tighten up the rules that restrict the use of global warming refrigerant gases including speeding up phase-out programmes and introducing new bans, according to a spokesman from the Department for Environment, Food and Rural Affairs (DEFRA).

Baxi research suggests schools strongly support heat decarbonisation

A survey conducted by Baxi of 200 state school estates managers, consultant engineers and M&E contractors has found that while enthusiasm for Net Zero and support for low carbon heating systems in schools is thriving, persistent barriers remain.

Calendar

Submit event

Tweets by MBS_magazine

KNX combined controllers and sensors from Siemens

Related links:

Related articles: