Electronic burner controls are SEL3 certified

30 January, 2009

The ETC6000 series of electronic burner controls from Energy Technology & Control has been certified for inclusion in an SIL3 (safety integrity level) loop.

This range of integrated burner controllers, fuel-air controllers and ancillary equipment that includes dedicated servo motors and process sensors has been independently tested and certified to conform to the requirements of EN 61508 (2001).

ETC customers had identified that this conformity was being increasingly specified in contracts.

For more information on this story, click here:Feb 09, 214

Related links:

More refrigerant bans possible, says government

The government could tighten up the rules that restrict the use of global warming refrigerant gases including speeding up phase-out programmes and introducing new bans, according to a spokesman from the Department for Environment, Food and Rural Affairs (DEFRA).

Baxi research suggests schools strongly support heat decarbonisation

A survey conducted by Baxi of 200 state school estates managers, consultant engineers and M&E contractors has found that while enthusiasm for Net Zero and support for low carbon heating systems in schools is thriving, persistent barriers remain.

Calendar

Submit event

Tweets by MBS_magazine