Clamp-on meter measures heat and energy consumption

03 June, 2015

Micronics’ U1000 HM heat-energy-meter device can be used straight out of the box with no programming or specialist engineering required. It is described as a cost-effective alternative to installing in-line meters and does not require pipes to be drained down or cut.

Using the U1000 HM simply involves clamping the unit to the pipe, selecting the pipe size, releasing the sensor clamps, securing the pre-wired clamp-on Pt100 flow and return temperature sensors and connecting power to the pre-wired cable supplied. Flow is measured ultrasonically.

Modbus compatibility enables the U1000 HM to be an integrated part of an aM&T system or a BEMS. It can also be used stand-alone.

For more information on this story, click here: June 2015, 161

Related links:

More refrigerant bans possible, says government

The government could tighten up the rules that restrict the use of global warming refrigerant gases including speeding up phase-out programmes and introducing new bans, according to a spokesman from the Department for Environment, Food and Rural Affairs (DEFRA).

Baxi research suggests schools strongly support heat decarbonisation

A survey conducted by Baxi of 200 state school estates managers, consultant engineers and M&E contractors has found that while enthusiasm for Net Zero and support for low carbon heating systems in schools is thriving, persistent barriers remain.

Calendar

Submit event

Tweets by MBS_magazine

Clamp-on meter measures heat and energy consumption

Related links:

Related articles: