Finder adds over-ride and status units to DIN modules

finder
Finder has added new modules to its 19 Series of DIN-rail modules.



Finder has added over-ride and status-monitoring modules to its 19 Series of 35 mm DIN-rail modules.

BMS designers, panel builders and installers will find these over-ride modules essential for providing a manual over-ride of a BMS controller or programmable logic controller — either in 0an emergency or during maintenance. Possibilities include control over pumps, fans, solenoid valves and motors.

The status modules provide a clear visual signal identification and permit BMS and panel designers to set the colour of the status LED during installation. This enables quick identification of operational status, particularly in complex systems.

An analogue output module has been added to the range, with a user-defined output of 0 to 10 V for proportional output setting or speed adjustment.

For more information on this story, click here: May 09, 108
Related articles:



modbs tv logo

More refrigerant bans possible, says government

The government could tighten up the rules that restrict the use of global warming refrigerant gases including speeding up phase-out programmes and introducing new bans, according to a spokesman from the Department for Environment, Food and Rural Affairs (DEFRA).

Baxi research suggests schools strongly support heat decarbonisation

A survey conducted by Baxi of 200 state school estates managers, consultant engineers and M&E contractors has found that while enthusiasm for Net Zero and support for low carbon heating systems in schools is thriving, persistent barriers remain.