Surface-mounted presence detector

04 July, 2013

CP Electroincs, presence detector, lighting control

CP Electronics’ EBDSPIR presence detector is now available as a surface-mounted version. It can be used for the automatic control of lighting, heating and ventilation. This versatile unit is self contained and easy to install via a back plate. it is also available as a flush-mounted unit for ceiling tiles.

This detector uses passive infra-red (PIR) to monitor the zone. It will switch on when occupancy is detected and off when the area is vacated following a preset time delay that can be adjusted between 10 s and 30 min.

If there is sufficient natural light, a built-in photocell will keep the lighting switched off. A manual on/off over-ride is available via an options infra-red handset.

There are no external control boxes, considerably reducing installation time.

For more information on this story, click here: July 2013, 164

Related links:

Carrier calls for prioritisation of ventilation in NHS infrastructure plans

As the healthcare sector begins to plan how new government infrastructure funding will be spent, Carrier is urging NHS estates teams to prioritise ventilation upgrades as part of long-term building improvement strategies.

Specifiers urged to act ahead of looming legislation

Specifiers are being encouraged to switch to efficient secondary hot water circulators ahead of anticipated legislation that will ban inefficient versions of these domestic and commercial plumbing products.

Calendar

Submit event

Tweets by MBS_magazine

Surface-mounted presence detector

Related links:

Related articles: