Automatic switch load control eliminates LED glow and flicker

Timeguard, lighting , control, dimming, LED, CFL

Timeguard’s ZV900 makes it possible to control LED and CFL lighting with smart switches without flicker or glow or prematurely burning out the switches. The device controls the switch load across a whole switching circuit. Once connected, it slips neatly through a standard 50 mm ceiling aperture.

Smart switches are typically designed as direct replacements for standard 2-wire light switches. The small current that they draw through the live connection can cause LED and CFL lighting to glow and flicker, which the Timeguard device prevents.

It also protects against the high inrush currents when LEDs are switched on, which can damage many switches — boosting the switching capability of most smart switches to 200 W.

The device itself consumes less than 1 W and can be used in new installations and retrofitted.

For more information on this story, click here: June 2016, 169
Related links:
Related articles:



modbs tv logo

More refrigerant bans possible, says government

The government could tighten up the rules that restrict the use of global warming refrigerant gases including speeding up phase-out programmes and introducing new bans, according to a spokesman from the Department for Environment, Food and Rural Affairs (DEFRA).

Baxi research suggests schools strongly support heat decarbonisation

A survey conducted by Baxi of 200 state school estates managers, consultant engineers and M&E contractors has found that while enthusiasm for Net Zero and support for low carbon heating systems in schools is thriving, persistent barriers remain.